NoWaistedSpace
PICK YOUR OWN
That's good to know. I have a burner, better start using it.I've burned sulphur weekly up to a week before chop, no issues and no noticable taste or smell of sulphur. Short 1 hr burns once every 5 days.
That's good to know. I have a burner, better start using it.I've burned sulphur weekly up to a week before chop, no issues and no noticable taste or smell of sulphur. Short 1 hr burns once every 5 days.
Im curious have you ever tried? Sulphur has the ability to penetrate plant tissue and it goes through a complex reaction in the respiratory chain that reduces it into hydrogen sulfide vapour. Takes around 5 days for the process to play out in Cannabis. Its worth pointing out sulphur is one of the most important and highly consumed nutrients for terpene production at the end of flower also.I wont use mine in the veg tent if I have flowers in the next tent I've read up to week 4 with sulphur but no thanks
If I had to use a burner week 7 I would find a new spot/ clean /clean pop some beans and try again
look up the ingredients of Flawless Finish by AN. Use, i think last week of flush or water. I don't use it, but you just explained to me why it is what it is, lol.Im curious have you ever tried? Sulphur has the ability to penetrate plant tissue and it goes through a complex reaction in the respiratory chain that reduces it into hydrogen sulfide vapour. Takes around 5 days for the process to play out in Cannabis. Its worth pointing out sulphur is one of the most important and highly consumed nutrients for terpene production at the end of flower also.
I spray with Ethanol late in flower. Just used it today on what looks like@Burned Haze props for recommending Marrone Bio, these guys are at the cutting edge of canna-approved biopesticides.
I was just visiting friends in Mendocino and I was told that from Day 1 they spray weekly with Lost Coast Plant Therapy. (A mix of Soybean Oil/Peppermint Oil/Water/Iso/Citric Acid)
I make something similar here and haven't seen pm indoors or outdoors for years.
This is what I do but keep in mind that this has a lot of oil and that trichs are also mostly oil. It can be really detrimental to your plant to spray late, or at all.
When using the Essential Oils for the first time, use it at a dose of maybe 2mL per Gallon. If you up to 10mL the first time, the plants, which are not used to the oils, may get burned. Start low and work your way up.
IPM 1-1: Foliar Spray
Container #1
2 cups of Warm Water
1.5 tsp Potassium Silicate (emulsifier)
1 tsp Aloe Vera Extract 200x
Container #2
1 tbs Mixed Essential Oils (ex. Cinnamon, Clove, Rosemary, Thyme)
1.5 tsp Neem Oil
1.5 tsp Karanja Oil
Container #3
1 Gallon of Warm Water (minus the 2 cups from Container #1)
Directions:
Mix Container #2 into Container #1
Stir, stir, stir
Pour into Container #3
Stir, Shake, Stir
Put into a sprayer and use immediately
Use up to 10 ml of mixed essential oils (usually 3 or 4 kinds):
Lavender
Cinnamon
Clove
Thyme
Rosemary (Melts mite eggs)
Citronella
Spearmint
Peppermint
Eucalyptus
Edit to note that I also add a little bit of Bronners as a surfactant.
Jeremy also has a version on his site: https://buildasoil.com/blogs/news/12284349-all-natural-spider-mite-or-powdery-mildew-prevention-and-cure
Hard to tell between spores or salt buildup. I'd use some Potassium Bicarbonate (green cure) on it to rule out the spores. Once you get it cleaned up, Id get that rooter covered with some vermiculite or something since those pots look pretty full already unless you can remove some of the hydroton and get the plug lower into the pot, and then re-cover it with the hydroton.
2 so far. Thanks. I didn't wanna hit the plug with anything but its not flower yet. Better noq than later. Maybe do the perlite and some sodium bicarbonate? I already tried to move em down unsuccessfully obviously. FMHard to tell between spores or salt buildup. I'd use some Potassium Bicarbonate (green cure) on it to rule out the spores. Once you get it cleaned up, Id get that rooter covered with some vermiculite or something since those pots look pretty full already unless you can remove some of the hydroton and get the plug lower into the pot, and then re-cover it with the hydroton.
Is it like that on all of em or just one pot?
Im curious have you ever tried? Sulphur has the ability to penetrate plant tissue and it goes through a complex reaction in the respiratory chain that reduces it into hydrogen sulfide vapour. Takes around 5 days for the process to play out in Cannabis. Its worth pointing out sulphur is one of the most important and highly consumed nutrients for terpene production at the end of flower also.
I would say it couldn't hurt to have a spray bottle of 10% bleach and include a misting of walls and floors as part of your attempts. Just keep out of direct contact with plants. Another good tool is beneficial fungi to compete like Actinovate.Ill look into the regalia it cant be more expensive than throwing top colas in the trash ive been hitting it once a week with green cure once a week with peroxide, and did my second sulfur burn last night, still small spots popping up here and there, gotta nuke the room after harvest if i make it and start fresh with the environment on point from the get go, got some funds on the way to help with some major upgrades si shits gonna get better for sure better lights and a bigger extraction filter and fan are on the list, gotta get rolling on my schwaggy and eso beans