Budget light setup

Slowdrawl

PICK YOUR OWN
I posted this in another thread, but thought I'd throw it out here as well.
For someone wanting to build a new setup this would be hard to beat.
Pretty smokin deal at $17.99 a board.

 

Slowdrawl

PICK YOUR OWN
That board doeant need a heatsink. So its very affordable
Figured you are the guy to ask (y)
I just received 4 of the above mentioned boards.
They have 5.5x2.1mm female barrel connector terminals??
I'm connecting these to a HLG 240H 48a driver.
None of the male barrel connectors that I can rind are rated for 48v, most 12 to 24dcv.
Should I just be concerned with an adequate amp rating?
 

TerpyTyrone

LED Recruiter
Hmm. Ive never seen that type before. As longas your running in parallel the voltage remains the same.
When ya start putting stuff in series the voltage adds up.
Whats the link for the male connector?
 

Slowdrawl

PICK YOUR OWN
Thx for the reply man.
For sure I'll wire in parallel, yeah these are new to me as well.
I just got a response this morning from Atreum saying that the only criteria is the connector should handle the amp rating of the driver.
I just ordered 4 male connectors with 16 gauge wire, should be more than enough for the 5 amp output of the driver.
 

TerpyTyrone

LED Recruiter
16 gauge is good up to 10 amps
Thx for the reply man.
For sure I'll wire in parallel, yeah these are new to me as well.
I just got a response this morning from Atreum saying that the only criteria is the connector should handle the amp rating of the driver.
I just ordered 4 male connectors with 16 gauge wire, should be more than enough for the 5 amp output of the driver.
 
Top